Alcatel-Lucent 6850-48 Guida Di Riferimento

OmniSwitch CLI Reference Guide

page 24-1

The LDP (Label Distribution Protocol) is used to set up Label Switched Paths (LSPs), also referred to as 
Multiprotocol Label Switching (MPLS) tunnels. These tunnels are used to connect customer sites over a 
service provider network and form the basis of any multipoint service, such as a Virtual Private LAN 
Service (VPLS). 

In addition to using LDP, configuring static LSPs is also supported. Both LDP and static LSPs provide the 
label switching mechanism required by MPLS. For more information about static LSPs, see the “Static 
LSP and FRR Commands” chapter in this guide.

MIB information for the LDP commands is as follows:

Filename: TIMETRA-LDP-MIB.mib
Module: TIMETRA-LDP-MIB

Filename: AlcatelIND1ServiceMgr.MIB
Module: Alcatel-IND1-SERVICE-MGR-MIB

A summary of the available commands is listed here: 

configure router ldp shutdown
show router ldp parameters
show router ldp peer
show router ldp session
show router ldp status

configure router ldp interface-parameters interface
configure router ldp interface-parameters interface shutdown
configure router ldp interface-parameters hello
configure router ldp interface-parameters keepalive
configure router ldp interface-parameters transport-address
show router ldp interface

configure router ldp targeted-session hello
configure router ldp targeted-session keepalive

configure router ldp graceful-restart-helper
configure router ldp reconnect-time
configure router ldp fwd-state-holding-time
configure router ldp maximum-recovery-time
configure router ldp neighbor-liveness-time

oam lsp-ping
oam lsp-trace