Alcatel-Lucent 6850-48 Guida Di Riferimento
Virtual Private LAN Service (VPLS) Commands
page 26-64
OmniSwitch CLI Reference Guide
September 2009
configure service vpls sap trusted
Configures the trust mode for the specified Service Access Port (SAP) ID. A SAP ID is comprised of a
customer-facing port (referred to as an access port) and an encapsulation value that is used to identify the
type of customer traffic to map to the associated service.
customer-facing port (referred to as an access port) and an encapsulation value that is used to identify the
type of customer traffic to map to the associated service.
A trusted SAP can accept 802.1p values in incoming packets; an untrusted SAP will set any 802.1p values
to zero in incoming packets, unless an 802.1p value is configured with this command.
to zero in incoming packets, unless an 802.1p value is configured with this command.
configure service vpls service-id sap {slot/port | linkagg agg_num} [:0 | :all | :qtag1] trusted
configure service vpls service-id sap {slot/port | linkagg agg_num} [:0 | :all | :qtag1] no trusted
priority value
priority value
Syntax Definitions
service-id
An existing VPLS ID number.
slot/port1
The slot and port number of the service access port.
agg_num
The link aggregate ID number (0–31) of a service access link aggregate.
:0
Specifies a null encapsulation value for the SAP. Depending on the pre-
configured encapsulation type for the access port, a SAP using a null
encapsulation will direct tagged and untagged or only untagged traffic to
the associated service.
configured encapsulation type for the access port, a SAP using a null
encapsulation will direct tagged and untagged or only untagged traffic to
the associated service.
:all
Specifies a wildcard SAP. All tagged or untagged traffic that is not clas-
sified into another SAP is mapped to the wildcard SAP. Not config-
urable on null encapsulation access ports.
sified into another SAP is mapped to the wildcard SAP. Not config-
urable on null encapsulation access ports.
:qtag1
Specifies a VLAN ID tag for traffic ingressing on the access port. Only
traffic with this tag is mapped to this SAP. Not configurable on null
encapsulation access ports.
traffic with this tag is mapped to this SAP. Not configurable on null
encapsulation access ports.
trusted
Allows the SAP to use the priority value obtained from tagged packets
ingressing on the SAP port. Untagged packets use the default port prior-
ity value.
ingressing on the SAP port. Untagged packets use the default port prior-
ity value.
value
The priority value to set. Values range from 0 (lowest priority) to 7
(highest priority). This is the priority assigned to tagged and untagged
packets ingressing on an untrusted SAP.
(highest priority). This is the priority assigned to tagged and untagged
packets ingressing on an untrusted SAP.
Defaults
By default, the SAP is trusted with the priority set to best effort (zero). These default values are set when a
port is configured as an access port and then associated with the SAP.
port is configured as an access port and then associated with the SAP.
Platforms Supported
OmniSwitch 9000E
parameter
default
:0 | :all | :qtag1
:0 (null)