Alcatel-Lucent 6850-48 Guida Di Riferimento
Virtual Private LAN Service (VPLS) Commands
OmniSwitch CLI Reference Guide
September 2009
page 26-93
show service id sap
Displays configuration information about the Service Access Points (SAPs) associated with the specified
service.
service.
show service id service-id sap [slot/port | linkagg agg_num] [:0 | :all | :qtag1]
Syntax Definitions
service-id
An existing VPLS ID number.
slot/port1
The slot and port number of the service access port.
agg_num
The link aggregate ID number (0–31) of a service access link aggregate.
:0
Specifies no (null) encapsulation value for the SAP. Depending on the
pre-configured encapsulation type for the access port, a SAP using a
null encapsulation will direct tagged and untagged or only untagged
traffic to the associated service.
pre-configured encapsulation type for the access port, a SAP using a
null encapsulation will direct tagged and untagged or only untagged
traffic to the associated service.
:all
Specifies a wildcard SAP. All 802.1q-tagged or untagged traffic that is
not classified into another SAP is mapped to the wildcard SAP. Not
configurable on null encapsulation access ports.
not classified into another SAP is mapped to the wildcard SAP. Not
configurable on null encapsulation access ports.
:qtag1
Specifies a VLAN ID tag for traffic ingressing on the access port. Only
traffic with this tag is mapped to this SAP. Not configurable on null
encapsulation access ports.
traffic with this tag is mapped to this SAP. Not configurable on null
encapsulation access ports.
Defaults
By default, a list of all SAPs associated with the specified service ID is displayed.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
To display detailed information for an individual SAP, specify a SAP ID using the slot/port and linkagg
agg-num parameters combined with the :0, :qtag, or :all parameters. For example, enter 1/2:all to display
information for the SAP on access port 1/2 that maps all traffic that is not classified into other SAPs to this
service.
agg-num parameters combined with the :0, :qtag, or :all parameters. For example, enter 1/2:all to display
information for the SAP on access port 1/2 that maps all traffic that is not classified into other SAPs to this
service.
Examples
-> show service id 100 sap
PortId SvcId
Adm
Oper
Trusted Pri
----------+------------+------+------+-------+-----
1/11:200
100
Up
Up
Yes
0
1/11:all
100
Up
Up
Yes
0
1/11:0
100
Down
Down
Yes
0
Number of SAPs : 3