Alcatel-Lucent 6850-48 Guida Di Riferimento
UDLD Commands
OmniSwitch CLI Reference Guide
September 2009
page 30-5
udld mode
Configures the operational mode of UDLD on a specific port, a range of ports, or all the ports.
udld port [slot/port[-port2]] mode {normal | aggressive}
Syntax Definitions
slot/port
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
module (e.g., 3/1 specifies port 1 on slot 3).
port2
The last port number in a range of ports that you want to configure on
the same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
the same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
normal
Specifies UDLD operation in the normal mode.
aggressive
Specifies UDLD operation in the aggressive mode.
Defaults
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• The UDLD protocol must be enabled before using this command.
• The UDLD protocol is not supported on aggregate ports.
• When two UDLD enabled ports that are configured in aggressive mode of operation gets the link-up
asynchonously, then the UDLD port which gets the link-up indication first is considered to be in the
shutdown state. In such case, the link should be configured manually after both the links are up to start
UDLD detection.
shutdown state. In such case, the link should be configured manually after both the links are up to start
UDLD detection.
• In case of faulty cable connection, the port which is configured in normal mode of operation is deter-
mined to be in the shutdown state.
Examples
-> udld mode aggressive
-> udld mode normal
-> udld port 1/3 mode aggressive
-> udld port 2/4 mode normal
-> udld port 2/9-18 mode aggressive
Release History
Release 6.3.1; command was introduced.
parameter
default
normal | aggressive
normal