Alcatel-Lucent 6850-48 Guida Di Riferimento

Power over Ethernet (PoE) Commands

page 4-14

OmniSwitch CLI Reference Guide

Configures an inline power priority level for a slot. If the power supply of the power shelf goes down, the 
order of a particular daughter module will be disabled based on priority, thus affecting the power budget 
available to the whole chassis. Levels include critical, high, and low.

lanpower slot slot-priority {critical | high | low}

The particular slot on which a priority level is being configured.

Intended for slots that have mission-critical devices attached and there-
fore require top (i.e., critical) priority. In the event of a power manage-
ment issue, inline power to critical ports is maintained as long as 
possible.

Intended for slots that have important, but not mission-critical devices 
attached. If other ports in the chassis have been configured as critical, 
inline power to high-priority ports is given second priority.

Intended for slots that have low-priority devices attached. In the event of 
a power management issue, inline power to low-priority ports is inter-
rupted first (i.e., before critical- and high-priority ports).

OmniSwitch 9000

• Note that if all the POE NI modules are all configured with the same priority level, then priority is 

determined based on the slot number of the module; the lower the slot number the higher the priority. 
For example, if slots 1, 2, 7, and 8 are powered by two POE power supplies and one of the power 
supplies goes down, power is cut to slots 7 and 8 because they have a lower priority than slots 1 and 2.

-> lanpower 1 slot-priority critical

-> lanpower 2 slot-priority high

-> lanpower 3 slot-priority low

Release 6.1.3; command was introduced.