Alcatel-Lucent 6850-48 Guida Di Riferimento

IPX Commands

OmniSwitch CLI Reference Guide

page 38-13

Creates/deletes an IPX SAP filter. IPX SAP filters allow you to minimize the number of entries put in the 
IPX SAP Bindery Table. SAP input filters control the SAP updates received by the switch prior to a 
switch accepting information about a service. The switch will filter all incoming service advertisements 
received before accepting information about a service. SAP output filters control which services are 
included in SAP updates sent by the switch.

ipx filter [vlan] sap {all | sap_type} {in | out} {allow | block} [network_number [mask network_mask] 
[network_node [mask node_mask]]]

no ipx filter [vlan] sap {all | sap_type} {in | out} {allow | block} [network_number [mask network_mask] 
[network_node [mask node_mask]]]

To apply the filter to a specific VLAN or delete a filter from a specific 
VLAN, enter the VLAN number.

Enter all to include all the SAP filters.

To configure a specific SAP filter, enter the 4-digit hex SAP filter type 
as defined by NetWare.

Filters incoming traffic.

Filters outgoing traffic.

Allows the traffic specified in the filter.

Blocks the traffic specified in the filter.

To apply the filter to a specific network or delete a filter from a specific 
network, enter the IPX network number.

If you are configuring a specific network, enter the network mask.

To apply the filter to a specific network node or delete a filter from a 
specific network node, enter the network node number. (You must also 
enter a network number and network mask as described above.)

If you are configuring a specific node, enter the node mask.