Alcatel-Lucent 6850-48 Guida Di Riferimento
BFD Commands
page 39-14
OmniSwitch CLI Reference Guide
September 2009
ip bfd-std interface multiplier
Configures the BFD interface dead interval multiplier. This command specifies a number that is used to
calculate the BFD detection time used in the asynchronous mode. When an interface stops receiving pack-
ets from a neighbor, the interface uses the detection time value to determine how long to wait before
declaring that the BFD session is down.
calculate the BFD detection time used in the asynchronous mode. When an interface stops receiving pack-
ets from a neighbor, the interface uses the detection time value to determine how long to wait before
declaring that the BFD session is down.
ip bfd-std interface interface_name multiplier multiplier_value
Syntax Definitions
interface_name
The name of an existing BFD interface.
multiplier_value
The dead interval multiplier number. The valid range is 1–10.
Defaults
By default, the multiplier value is set to 3.
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
The detection time between neighbors is calculated by multiplying the negotiated transmit time interval by
the dead interval multiplier.
the dead interval multiplier.
Examples
-> ip bfd-std interface bfd-vlan-101 multiplier 5
Release History
Release 6.3.4; command was introduced.
Related Commands
MIB Objects
alaBfdIntfTable
alaBfdIntfDetectMult
Creates a BFD interface.
Displays the BFD interface configuration table.
Displays the BFD interface configuration table.