Alcatel-Lucent 6850-48 Guida Di Riferimento

PIM Commands

OmniSwitch CLI Reference Guide

page 45-79

Statically maps the specified IPv6 multicast group(s) to the PIM Dense mode (DM).

ipv6 pim dense group group_address/prefix_length [[no] override] [priority priority]

no ipv6 pim dense group group_address/prefix_length 

Specifies the IPv6 multicast group address.

Specifies the prefix length of the IPv6 multicast group.

Specifies the static dense mode mapping configuration to override the 
dynamically learned group mapping information for the specified 
group(s).

Specifies the preference value to be used for this static configuration 
and provides fine control over which configuration is overridden by this 
static configuration. Values may range from 0 to 128.

By default, the priority option is not set and the override option is set to false.

OmniSwitch 6850, 6855, 9000, 9000E

• Use the no form of this command to remove a static configuration of a dense mode group mapping.

• This command specifies the mode as Dense (PIM-DM) for the specified IPv6 multicast group 

addresses.

• If the group prefixes configured for two or more rows in this table overlap, the row with the greatest 

prefix length value is used for the overlapping range.

• Specifying the priority value obsoletes the override option and once the priority option has been 

defined, a value of 65535 can be used to un-set the priority.

-> ipv6 pim dense group ff0e::1234/128 priority 50

-> no ipv6 pim dense group ff0e::1234/128

Release 6.3.1; command was introduced.