Alcatel-Lucent 6850-48 Guida Di Riferimento
PIM Commands
page 45-92
OmniSwitch CLI Reference Guide
September 2009
show ipv6 pim sparse
Displays the status of the various global parameters for the IPv6 PIM sparse mode.
show ipv6 pim sparse
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 9000, 9000E
Usage Guidelines
N/A
Examples
-> show ipv6 pim sparse
Status = enabled,
Keepalive Period = 210,
Max RPs = 32,
Probe Time = 5,
Register Suppress Timeout = 60,
RP Switchover = enabled,
SPT Status = enabled,
output definitions
Status
The current global (i.e., switch-wide) status of the IPv6 PIM sparse
mode. Options include enabled and disabled.
mode. Options include enabled and disabled.
Keepalive Period
The duration of the Keepalive timer. The default value is 210.
Max RPs
The maximum number of Rendezvous Points (RPs) allowed in the IPv6
PIM-SM domain (1–100). The default value is 32.
PIM-SM domain (1–100). The default value is 32.
Probe Time
The amount of time before the Register Suppression timer expires, at
which point the Designated Router (DR) sends a Null Register message
to the Rendezvous Point (RP). This allows the RP to refresh the Regis-
ter-Stop. If the Register Suppression timer expires, the DR will resume
encapsulating packets from the source to the RP. Values may range
from 1 to 300. The default value is 5.
which point the Designated Router (DR) sends a Null Register message
to the Rendezvous Point (RP). This allows the RP to refresh the Regis-
ter-Stop. If the Register Suppression timer expires, the DR will resume
encapsulating packets from the source to the RP. Values may range
from 1 to 300. The default value is 5.
Register Suppress Timeout
The amount of time, in seconds, the Designated Router (DR) will stop
sending registers to the Rendezvous Point (RP) once a Register-Stop is
received (1–300). The default value is 60.
sending registers to the Rendezvous Point (RP) once a Register-Stop is
received (1–300). The default value is 60.