Alcatel-Lucent 6850-48 Guida Di Riferimento

QoS Policy Commands

OmniSwitch CLI Reference Guide

page 53-61

Configures a destination IP port number for a policy condition.

policy condition condition_name destination ip port port[-port]

policy condition condition_name no destination ip port

The name of the condition.

The TCP or UDP port number (or port range) of the destination address 
of the Layer 3 flow, in the range from 0–65535. A range of ports (sepa-
rated by a hyphen) may be specified instead of a single port.

N/A

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Use the no form of the command to remove a destination IP port from a condition; however, at least 

one classification parameter must be associated with a condition.

• The protocol (TCP or UDP) must be specified in the same condition, either on the same command line 

or in a previous command. Use the ip protocol keywords. See the 

command for more information.

• The same condition cannot specify a destination IP port with a service or service group.

-> policy condition cond2 ip protocol 6 destination ip port 137-138

Release 6.1; command was introduced.

Applies configured QoS and policy settings to the current configuration. 

Configures an IP protocol for a policy condition.

Shows information about policy conditions configured on the switch.