Alcatel-Lucent 6850-48 Guida Di Riferimento

QoS Policy Commands

page 53-156

OmniSwitch CLI Reference Guide

Sends hypothetical information to the Layer 2, Layer 3, or multicast classifier to see how the switch will 
handle the packet. Used to verify that a policy rule works a particular way.

This section describes the base command. Optional keywords are listed below and described as separate 
commands later in this chapter. (Note that options may be used in combination but are described sepa-
rately for ease in explanation.)

[source port slot/port]
[destination port slot/port]
[source mac mac_address]
[destination mac mac_address]
[source vlan vlan_id]
[destination vlan vlan_id]
[source interface type {ethernet | wan | ethernet-10 | ethernet-100 | ethernet-1G | ethernet-10G}]
[destination interface type {ethernet | wan | ethernet-10 | ethernet-100 | ethernet-1G | ethernet-
10G}]
[802.1p value]
[source ip ip_address] 
[destination ip ip_address] 
[multicast ip ip_address] 
[tos tos_value]
[dscp dscp_value]
[ip protocol protocol] 
[source ip port port]
[destination ip port port]

Uses the Layer 2 classifier for the hypothetical packet. Typically speci-
fied for port, MAC address, VLAN, interface type, or 802.1p.

Uses the Layer 3 classifier for the hypothetical packet. Typically speci-
fied for interface type, IP address, ToS or DSCP, IP protocol, or TCP/
UDP port.

Uses the multicast IGMP classifier for the hypothetical packet. Typi-
cally specified for multicast IP address (which is the multicast stream) 
and destination parameters (for the client issuing an IGMP request).

Indicates that only applied policies should be examined. 

By default, only pending policies are examined.

OmniSwitch 6400, 6850, 6855, 9000, 9000E