Alcatel-Lucent 6850-48 Guida Di Riferimento

Link Aggregation Commands

OmniSwitch CLI Reference Guide

page 12-7

Configures a slot and port for a static aggregate group.

static agg [ethernet | fastethernet | gigaethernet] slot/port agg num agg_num

static agg no [ethernet | fastethernet | gigaethernet] slot/port

Documents that the port is 10 Mbps Ethernet.

Documents that the port is 100 Mbps Fast Ethernet.

Documents that the port is Gigabit Ethernet.

The slot number for this aggregate.

The port that the switch will initially use as the Spanning Tree virtual 
port for this aggregate.

The number corresponding to the static aggregate group.

N/A

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Use the no form of this command to remove one or more ports from a static aggregate group.

• Mobile ports cannot be aggregated.

• A port may belong to only one aggregate group.

• Ports in a static aggregate must all be the same speed (e.g., all 10 Mbps, all 100 Mbps, all 1 Gigabit, or 

all 10 Gigabit).

• Ports that belong to the same static aggregate group do not have to be configured sequentially and can 

be on any Network Interface (NI) or unit within a stack.

• The ethernet, fastethernet, and gigaethernet keywords do not modify a port’s configuration. See 

 for information on CLI commands to configure Ethernet 

ports.

-> static agg 2/1 agg num 4

-> static agg no 2/1