Alcatel-Lucent 6850-48 Guida Di Riferimento
Distributed Spanning Tree Commands
page 15-118
OmniSwitch CLI Reference Guide
September 2009
show spantree
Displays Spanning Tree bridge information for the flat mode Common and Internal Spanning Tree (CIST)
instance or a 1x1 mode VLAN instance.
instance or a 1x1 mode VLAN instance.
show spantree [instance]
Syntax Definitions
instance
The flat mode CIST instance or an existing VLAN ID number (1–4094).
Defaults
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• If an instance number is not specified, this command displays the Spanning Tree status, protocol, and
priority values for all instances.
• Specifying an instance number with this command when the switch is running the 1x1 Spanning Tree
operating mode implies a VLAN ID and displays Spanning Tree bridge information for the associated
VLAN instance.
VLAN instance.
• If the switch is running in the flat mode and STP (802.1D) or RSTP (802.1W) is the active protocol,
enter 1 to specify the CIST instance. If MSTP is the active protocol, however, entering 1 for the
instance number is not accepted. In this case, use the
instance number is not accepted. In this case, use the
or
commands instead.
Examples
-> bridge mode flat
-> bridge protocol rstp
-> show spantree
Spanning Tree Path Cost Mode : AUTO
Bridge STP Status Protocol Priority(Prio:SysID)
------+----------+--------+--------------------
1 ON RSTP 32768 (0x8000:0x0000
parameter
default
instance
all instances