Alcatel-Lucent 6850-48 Guida Di Riferimento

Source Learning Commands

page 17-26

OmniSwitch CLI Reference Guide

Displays the static multicast MAC address configuration for the switch. 

show mac-address-table static-multicast [multicast_address] [slot slot | slot/port] [linkagg link_agg] 
[vid | vid1-vid2]

Enter a multicast MAC Address (e.g., 01:00:39:59:f1:0c).

Enter the slot number for a module to specify that the command should 
include all ports on that module (e.g., 6 specifies all ports on the module 
found in slot 6 of the switch chassis).

Enter the slot number and the physical port number on that module 
(e.g., 3/1 specifies port 1 on slot 3).

Enter a link aggregate ID number (0–29). See Chapter 12, “Link Aggre-
gation Commands.”

VLAN ID number (1–4094).

The last VLAN ID number in a range of VLANs that you want to 
configure (e.g. 10-12 specifies VLANs 10, 11, and 12).

By default, information is displayed for all static multicast MAC addresses contained in the MAC address 
table.

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Note that only one VLAN entry—a single VLAN ID or a range of VLAN IDs— is allowed with this 

command. Multiple entries are not accepted.

• Note that if a static multicast MAC address is configured on a port link that is down or disabled, the 

configured multicast address does not appear in the show mac-address-table static-multicast 
command display.

• The show mac-address-table command display, however, includes all static multicast addresses 

regardless of whether or not the port assigned to the address is up or down. See the second example 
below.

• When the show mac-address-table command is used to display MAC addresses known to the switch, 

an asterisk appears to the left of all static MAC addresses that are configured on a port link that is down 
or disabled. The asterisk indicates that MAC address is invalid. When the port link comes up, however, 
the MAC address is then considered valid and the asterisk no longer appears next to the address in the 
display.