Alcatel-Lucent 6850-48 Guida Di Riferimento

Ethernet Port Commands

OmniSwitch CLI Reference Guide

page 19-17

Configures a dedicated VLAN for carrying end-to-end (E2E) flow control messages to remote systems. 
Creating this type of VLAN is required to enable E2E flow control on 48-port OmniSwitch 6400 and 
OmniSwitch 6850 units.   

interfaces e2e-flow-vlan vlan_id 

The VLAN ID number for the dedicated flow VLAN.

OmniSwitch 6400, 6850

N/A

• Note that if the standalone switch is a 24-port unit, then only the 

required to enable end-to-end (E2E) flow control. However, if the switch is a 48-port unit, then a flow 
control VLAN, which is configured using the interfaces e2e-flow-vlan command, is required in addi-
tion to enabling RX/TX pause flow control.

• Use the no form of this command to remove the flow VLAN from the switch configuration.

• There is only one flow control VLAN allowed per switch.

• No other standard VLAN management commands are allowed once a VLAN is configured as a dedi-

cated flow control VLAN.

-> interfaces e2e-flow-vlan 10

-> interfaces no e2e-flow-vlan

Release 6.3.4; command was introduced.