Alcatel-Lucent 6850-48 Guida Di Riferimento

Ethernet Port Commands

OmniSwitch CLI Reference Guide

page 19-69

Displays interface counters information (e.g., unicast, broadcast, and multi-cast packets received/transmit-
ted).

show interfaces [slot[/port[-port2]]] counters 

Slot number you want to display.

Port number of the interface you want to display.

Last port number in a range of ports you want to display.

N/A

OmniSwitch 6400, 6850, 6855, 9000

• If no slot/port numbers are entered, counter information for all slots/ports on the switch is displayed.

• You can display a specific interface by entering the slot and port number (e.g., 3/1).

• You can display a range of port numbers (e.g., 3/1-4).

• You can display all interfaces in a slot by entering the slot number (e.g., 3).

• These counters do not apply to Gigabit Ethernet traffic.

• On a combo port configured as either forced fiber or preferred fiber statistics for the SFP fiber ports 

and not the copper RJ-45 10/100/1000 ports will be displayed. See the 

 command for more information.

• On a combo port configured as either forced copper or preferred copper statistics for the copper RJ-45 

10/100/1000 ports and not the SFP fiber port will be displayed. See the 

 command for more information.

• This command also displays sampling interval statistics that show an average traffic rate per second for 

active switch interfaces. These statistics are taken every 5 seconds. The actual statistics shown are 
those taken from the last completed 5-second time interval.

• Note that the sampling interval time period is set to five seconds and is not a configurable value at this 

time. In addition, the sampling interval is a global value that applies to all switch ports.