Alcatel-Lucent 6850-48 Guida Di Riferimento

Port Mobility Commands

page 20-14

OmniSwitch CLI Reference Guide

Defines a binding port-protocol rule for an existing VLAN. This rule restricts VLAN membership to a 
device that matches all criteria of the rule. Device frames received on the specified mobile port must 
contain a protocol type that matches the protocol value specified in the rule. 

vlan vid binding port-protocol slot/port {ip-e2 | ip-snap | ipv6 | ipx-e2 | ipx-novell | ipx-llc | ipx-snap | 
decnet | appletalk | ethertype type | dsapssap dsap/ssap | snap snaptype}

vlan vid no binding port-protocol slot/port {ip-e2 | ip-snap | ipx-e2 | ipx-novell | ipx-llc | ipx-snap | 
decnet | appletalk | ethertype type | dsapssap dsap/ssap | snap snaptype}

VLAN ID number (1–4094).

The slot number for the module and the physical mobile port number on 
that module (e.g., 3/1 specifies port 1 on slot 3).

IP Ethernet-II protocol. Also captures Address Resolution Protocol 
(ARP).

IP SNAP protocol.

IPv6 protocol.

IPX Ethernet-II protocol.

IPX Novell (802.3) protocol.

IPX LLC (802.2) protocol.

IPX SNAP protocol.

DECNET Phase IV (6003) protocol.

AppleTalk protocol. Also captures Datagram Delivery Protocol (DDP) 
and AppleTalk ARP (AARP).

A two-byte hex value between 0x600 and 0xffff that defines an Ether-
net type (e.g., 0600, 0806, 6002). 

A one-byte hex value between 0x00 and 0xff that defines Destination 
Service Access Protocol (DSAP) and Source Service Access Protocol 
(SSAP) header values. Specify both a DSAP and an SSAP value for this 
parameter variable (e.g., F0/F0, 04/04, BC/BC).

A two-byte hex value between 0x600 and 0xffff that defines a Sub-
network Access Protocol (SNAP) protocol.

N/A

OmniSwitch 6400, 6850, 6855, 9000, 9000E