Fujitsu 3400 Manuale Utente

INSTALLING THE RADIO ANTENNA COVER

To attach the radio antenna cover to the pen tablet PC,
perform the following steps.

1. Position the antenna cover in relation to the back of the

pen tablet PC as shown in Figure 2.

2. If caps are present over the mounting holes, remove

them with a small screwdriver, or similar tool.

3. If the FMW42CR2 antenna cover is being used, slide the

open slot in the cover (as outlined in Figure 2) over the
antenna so that the antenna protrudes from the cover.

4. Insert the antenna cover tabs into the two tab slots on

the pen tablet.

Note: If the screws referenced in the step below are either lost or

missing, they can be purchased at most hardware stores (Cross-recessed
head Machine Screw with spring washer and flat washer. Size: M2.5 x
8 mm long. Finish:Black Zinc)

5. Insert the two black screws through the holes in the

hood and secure them to the pen tablet.

Figure 2. Installing the Radio Antenna Cover

PC Card Slot

Tab

Tab Slots

Mounting
Hole

Antenna Slot
(FMW42RC2
model only)

58_0497_02.fm Page 3 Tuesday, July 10, 2001 2:18 PM