Intellinet 519021 Guida Utente
Modularized 24+2G Switch
13
the Switch will retry send 48 times and before dropping the frame.
Enable – In half-duplex, if collision occurs, the Switch will retry to send
frames indefinitely.
Enable – In half-duplex, if collision occurs, the Switch will retry to send
frames indefinitely.
2-5-3. Console Port Information
1. Console is a standard UART interface to communicate with the
Serial Port. The user can launch windows HyperTerminal program
to link with the switch. See section three for details
to link with the switch. See section three for details
Bits per seconds: 38400
Data bits: 8
Parity: none
Stop Bits: 1
Flow control: none
Data bits: 8
Parity: none
Stop Bits: 1
Flow control: none
Modularized 24+2G Switch
14
2-5-4. Port Controls
Use this page to change the status of each port.
1. State:
User can disable or enable this port control.
2. Auto-Negotiation:
User can set auto-negotiation modes:
Force - specify the speed/duplex on this port with auto-negotiation
enable.
Auto NWay – for the Switch to automatically determine the highest
speed and duplex mode possible
enable.
Auto NWay – for the Switch to automatically determine the highest
speed and duplex mode possible
3. Speed:
User can set 100Mbps or 10Mbps speed on Port1~Port24.
User can set 1000Mbps, 100Mbps or 10Mbps speed on
Port25~Port26 (depending on module card specifications).
Port25~Port26 (depending on module card specifications).
4. Duplex:
User can set full duplex or half-duplex mode for each port.
5. Flows
control:
Full: User can set full - flow control function (pause).
Half: User can set half – flow control (backpressure).
Half: User can set half – flow control (backpressure).