Printronix SL4M Manuale Utente
151
5
Downloading Software
Loading Flash Memory
Flash memory is contained in a SIMM (single in-line memory module) located
on the controller PCBA. Printer control languages (the “emulations”) and
printer operating system software are loaded into flash memory at the factory,
but there are occasions when you may have to load this software:
on the controller PCBA. Printer control languages (the “emulations”) and
printer operating system software are loaded into flash memory at the factory,
but there are occasions when you may have to load this software:
•
You have replaced the controller PCBA
•
You have replaced flash memory
•
The customer needs to upgrade printer software
•
The customer needs different emulation software
•
The customer buys the PGL or VGL graphics language, the
CT option, the IPDS option, or the ethernet NIC (network interface card)
option after the printer is installed
CT option, the IPDS option, or the ethernet NIC (network interface card)
option after the printer is installed
Emulation and operating system software are included as files on a CD that
comes with the printer. You will copy the appropriate file from the
CD to a computer’s hard disk, then download the file from the computer into
printer memory.
comes with the printer. You will copy the appropriate file from the
CD to a computer’s hard disk, then download the file from the computer into
printer memory.
IMPORTANT
When downloading emulation and operating system software to the
printer, all other optional fonts, customer-supplied logos, setup files,
feature files, and TIFF files will be erased. You will then need to reload
those files. Before starting a download procedure, be sure that you have
all the necessary files on hand.
printer, all other optional fonts, customer-supplied logos, setup files,
feature files, and TIFF files will be erased. You will then need to reload
those files. Before starting a download procedure, be sure that you have
all the necessary files on hand.
You can load software through the serial, parallel, USB, or ethernet port of the
printer, and you can do it four ways:
printer, and you can do it four ways:
•
You can load software through any printer port except USB by using the
Firmware Download Utility included on the CD that comes with the printer.
(See page 152.)
Firmware Download Utility included on the CD that comes with the printer.
(See page 152.)
•
You can use a command prompt session to load software through the
parallel port. (See page 153.)
parallel port. (See page 153.)
•
If the printer has the NIC installed, you can load software through the
ethernet port. (See page 154.)
ethernet port. (See page 154.)
•
You can use a command prompt session to load software through the
USB port (See page 158.)
USB port (See page 158.)