Printronix SL4M Manuale Utente
MEDIA SETUP Submenus
83
TOF Detect Fault
Allows selection of three different TOF (Top-of-Form) detection faults.
NOTE: The correct Label Length value, equal to the physical length of the
installed label, must be entered MEDIA SETUP menu.
•
3 Labels (factory default). The printer displays a Gap Not Detected fault
and stops printing when media has advanced a distance equal to three or
more times the Label Length value set in menu.
and stops printing when media has advanced a distance equal to three or
more times the Label Length value set in menu.
•
9 Labels
•
1 Label
TOF Adjust Mode
•
Disable (factory default). This option disables the “TOF Adjust” distance
set using the TOF Adjust menu (see TOF Adjust below).
set using the TOF Adjust menu (see TOF Adjust below).
•
Enable. This option enables the “TOF Adjust” distance set using the TOF
Adjust menu (see TOF Adjust below).
Adjust menu (see TOF Adjust below).
Ticket Save Mode
This option determines the action of the media for Continuous (std), Tear-Off,
Tear-Off Strip and Cut Media Handling Modes after the printer is first powered
up or after the printhead has been opened and then closed. When enabled,
this option eliminates wasting label(s) or ticket stock when the printer
advances media to search for the next TOF position.
Tear-Off Strip and Cut Media Handling Modes after the printer is first powered
up or after the printhead has been opened and then closed. When enabled,
this option eliminates wasting label(s) or ticket stock when the printer
advances media to search for the next TOF position.
•
Enable. The printer will assume that media is at the TOF position after
cycling power or after the printhead is opened and then closed. When a
print job is sent it is printed without advancing media to search for the next
TOF position.
cycling power or after the printhead is opened and then closed. When a
print job is sent it is printed without advancing media to search for the next
TOF position.
NOTE: The user must ensure that media is at the correct TOF position (cross
perforation, liner gap, notch or mark at the tear bar edge) before
cycling power or before closing and locking the pivoting deck. In
addition, media must be calibrated and the correct Media Handling
Mode, Label Length and Gap/Mark Sensor selected and saved as the
Power-Up Config. Option applies to 3.75 inch or longer label lengths
only.
cycling power or before closing and locking the pivoting deck. In
addition, media must be calibrated and the correct Media Handling
Mode, Label Length and Gap/Mark Sensor selected and saved as the
Power-Up Config. Option applies to 3.75 inch or longer label lengths
only.
•
Disable (factory default). The printer assumes that the media is not at the
correct TOF position after cycling power or after the printhead is opened
and then closed and advances media until the next gap, notch or mark is
detected by the Media Sensor(s). When print data is sent, printing begins
only after the next TOF is detected, resulting in one or more blank labels
being advanced.
correct TOF position after cycling power or after the printhead is opened
and then closed and advances media until the next gap, notch or mark is
detected by the Media Sensor(s). When print data is sent, printing begins
only after the next TOF is detected, resulting in one or more blank labels
being advanced.
NOTE: When set to Enable, Online Auto-Cal and Head-Auto-Cal will
automatically be set to Disable. The printer will not reset any settings
to Enable when Ticket Save Mode is later disabled.
to Enable when Ticket Save Mode is later disabled.