Printronix SL4M Manuale Utente
EMULATION Submenus
105
Vertical Adjust
This option is to adjust printer dpi to expand or shrink the vertical position of
graphic elements and the height of the vertical line. The factory default is 0
dots. The adjustment range is from -20 dots to 20 dots with respect to the
current printer dpi.
graphic elements and the height of the vertical line. The factory default is 0
dots. The adjustment range is from -20 dots to 20 dots with respect to the
current printer dpi.
Error Report
This item sets the error reporting capability of the printer for PGL forms as
follows:
follows:
•
On (factory default). Full error checking reported. Any element that falls
off the current page is reported as an error.
off the current page is reported as an error.
•
Debug Mode. Puts the printer in debug mode whenever a form is defined
in CREATE mode. Each line of the CREATE form will be printed along
with an error if one has occurred.
in CREATE mode. Each line of the CREATE form will be printed along
with an error if one has occurred.
•
Fault. Allows you to halt the printer if a PGL error occurs. If you select this
option, the PGL error prints on the paper, the message “IGP/PGL Error”
displays on the front panel, and the printer goes offline. You must clear
the error before the printer can resume normal operation.
option, the PGL error prints on the paper, the message “IGP/PGL Error”
displays on the front panel, and the printer goes offline. You must clear
the error before the printer can resume normal operation.
•
Off. There is no error checking whatsoever. Graphic elements such as
alpha, line, barcodes, etc. will be clipped if they are beyond the page
boundaries.
alpha, line, barcodes, etc. will be clipped if they are beyond the page
boundaries.
Boundary Check
This option turns on or off the page boundary check for all print elements.
•
Enable (factory default). When enabled, an out of bound error is reported
if the print element is out of the page boundary.
if the print element is out of the page boundary.
•
Disabled. When disabled, no out of bound error is reported. The out of
bound print element prints over the page boundary.
bound print element prints over the page boundary.
Repeat Form Opt
•
Enable (factory default). Speeds up the processing of repeated forms for
PGL, thereby resulting in increased printer throughput. This option
provides no speed benefit for forms that are unrelated to one another and
should be disabled under those circumstances.
PGL, thereby resulting in increased printer throughput. This option
provides no speed benefit for forms that are unrelated to one another and
should be disabled under those circumstances.
•
Disable. Should be selected when subsequent forms are unrelated to
one another.
one another.
Preparser Cmd
Allows users to select which preparser command to use. Once the command
is selected, the command will be executed immediately when it is sent to the
printer.
is selected, the command will be executed immediately when it is sent to the
printer.
•
Status (factory default). Select (STCC) STATUS command.
•
Cancel. Select (STCC) CANCEL command.