Printronix SL4M Manuale Utente
148
Chapter
4
Modifying A Saved Configuration
NOTE: If the configuration number has not been saved previously, the
following error message displays:
If this error message displays, see “Saving A Configuration” on
page 144. Once you have saved a configuration, repeat the steps in
this procedure.
page 144. Once you have saved a configuration, repeat the steps in
this procedure.
Modifying A Saved Configuration
You can change a saved configuration by rewriting over it. For example, you
can modify Config. 1, shown below. Suppose you want to keep all the settings
but you want to select the parallel Centronics interface instead of the
IEEE 1284 interface.
can modify Config. 1, shown below. Suppose you want to keep all the settings
but you want to select the parallel Centronics interface instead of the
IEEE 1284 interface.
1.
Load the configuration to be changed (for example, Config. 1).
a.
Press the
key to enter the menu configuration. MEDIA SETUP is
selected.
b.
Press the Right key until the following displays:
c.
Press the
↵ key to enter the CONFIGURATION menu.
d.
Press the Down key until the following displays:
e.
Press the Left or Right keys to cycle through the options Factory, 1-8.
f.
When the desired number displays, press the
↵ key to select it. The
following message displays:
Then, the following message displays when it is loaded:
2.
Move through the menu and change all the desired values. (In this
example, press the
example, press the
key then the Right key until EMULATION
displays. Press the Right key until Select: IGL displays.
3.
Press the
↵ key to select each new value. An asterisk (*) displays.
CONFIG. DOES NOT
EXIST/Save First
EXIST/Save First
..
.
CONFIGURATION
Load Config.
1*
Loading Saved
Configuration
Configuration
Load Config.
X*
..
.