Printronix P5000 Guida All'Installazione Rapida

86 

When a fault condition occurs, the status indicator flashes, the alarm 

sounds, and a specific message appears in the display. When this 

happens, correct the fault immediately. 

You can correct most faults by performing a simple procedure, such as 

clearing a paper jam or reloading paper. The following pages list common 

fault messages and explain how to correct the fault conditions.

For more serious faults, indicated by an asterisk (*) following the fault 

message, a Hewlett-Packard Customer Service Engineer will be needed. 

For error messages not covered in this guide, refer to your 

Maintenance 

Manual.

Perform the following steps to clear a fault message after you have 

corrected the fault condition: 

1.

Press CLEAR, then ON LINE to continue printing.

2.

If the fault message reappears, turn the printer power off, wait 15 
seconds, then turn the printer back on. Run your print job again. If the 
message does not reappear during printing, no further attention is 
required. If the fault message reappears, go to step 3.

3.

Press ON LINE again and resume printing. If the message does not 
appear, no further attention is required. If the message reappears, call 
your Hewlett-Packard Customer Service Engineer.

Faults indicated by an asterisk (*) prevent further printer operation, and the 
printer power must be turned off to clear the fault.