Printronix SL5000 Manuale Di Riferimento
138
Chapter
5
Configuring the Proprinter III XL Emulation with Control Codes
n3
Parameter
n3 is provided for compatibility with the Proprinter III XL printer
control language standard. You may define any value for this parameter. (For
Proprinters, this bit must define the attached printer as either Proprinter, value
03, or Proprinter III XL, value 22 [hex 16].)
Proprinters, this bit must define the attached printer as either Proprinter, value
03, or Proprinter III XL, value 22 [hex 16].)
n4
and
n5
Parameter bytes
n4 and n5 allow you to define several configuration
parameters that will override conflicting factory default and memory-based
configuration values when the printer is reinitialized. Possible values for
configuration values when the printer is reinitialized. Possible values for
n4
and
n5 are listed in Table 29 and Table 30, respectively.
NOTE: In addition to the formatting from bytes
n4 and n5, this command sets
the current line as top-of-form. It also clears vertical tabs and sets the
horizontal tabs at every eight columns, starting at column 9.
horizontal tabs at every eight columns, starting at column 9.
Table 29.
n4 Values
n4 Bit
Function
OFF (0)
ON (1)
7
Process this byte
Process
Ignore
6
Reserved
Reserved
Reserved
5
n/a
n/a
n/a
4
Line Feed =
LF
LF + CR
(add CR with each LF)
(add CR with each LF)
3
Carriage Return =
CR
CR + LF
(add LF with each CR)
(add LF with each CR)
2
Set forms length
11 inches
12 inches
1
Slashed Zero
Disable
Enable
0
Character set
1 (A)
2 (B)