Philips 32" LCD TV Pixel Plus 2 32PF9967 Manuale Proprietario

37

English

• Have you selected the correct TV system in the manual installation menu?
• Is your TV or house aerial located too close to loudspeakers, non-earthed audio 

equipment or neon lights, etc?

• Mountains or high buildings can cause double pictures or ghost images.

Sometimes you can improve the picture quality by changing the direction of the
aerial.

• Is the picture or teletext unrecognisable? Check if you have entered the correct

frequency. See Installation, Manual installation, p. 18.

• Are brightness, sharpness and contrast out of adjustment? 

Select Factory settings in the Setup, General menu, p. 20.

• Are the supplied cables connected properly ? (The aerial cable to the TV, the 

other aerial to your recorder, the VGA cables to the display, the power cables.)

• Has the child lock been switched off ?
• Is your PC switched on ?
• Do you see a black screen and the indicator in front of the TV lights up blue,

this means that the display mode is not supported. Switch your VGA-source to 
a correct display mode.

• In case of weak or bad signal, consult your dealer.

The low quality of some digital picture material may be the cause of digital image
distortion. In this case select the Soft setting using the Picture menu, Smart
Picture, without changing the picture settings manually.

• No sound on any channel? Check the volume isn’t at minimum.
• Is the sound interrupted with the mute key ¬? 

Switch your TV off and then on again once. Never attempt to repair a defective   

TV yourself. Check with your dealer or call a TV technician.

(After checking the installation/signal from aerial) Either:
• Your aerial is not pointing properly at the digital TV transmitter;
• Your aerial installation needs to be upgraded:
• You are not in the coverage area to correctly receive digital television.
For a proper diagnosis, call our electrical retailer.

• Check if the remote control is in the correct mode.
• If your TV no longer responds to the remote control, the batteries may be dead.
• You can still use the 

key and the -/+ keys on the right side of your TV.

Your TV consumes energy in the standby mode. Energy consumption contributes 
to air and water pollution. Power consumption: 2 W.

Check if you have selected the correct VGA mode in your PC.

24571.1 en.qxd  31-08-2005  11:59  Pagina 37