Netgear gsm7312 Manuale Utente

7-62

Switching Commands

This command specifies which configured server should be the primary server for this RADIUS 
client. The primary is the server that is used by default for handling RADIUS requests. The 
remaining configured servers are used only if the primary server cannot be reached. A maximum 
of three servers can be configured on each client. Only one server can be configured as the primary 
server. If a primary server is currently configured and this command is issued, the server specified 
by the IP address used in this command will become the new primary server. The IP address 
specified must match that of a configured server.

This command enables or disables the message authenticator attribute for the specified RADIUS 
server. Enabling the message authenticator attribute provides additional security in the connection 
between the RADIUS client and the RADIUS server. Some RADIUS servers require enabling the 
message authenticator attribute for authentication requests from the RADIUS client to be 
accepted. The IP address specified must match that of a configured server.

config radius server msgauth <ipaddr> <enable/disable>

This command displays the following RADIUS configuration items for the switch. 

Current Server IP address    The IP address of the server currently used for authentication.

 

The number of RADIUS servers that have been configured. This value will be in 
the range of 0 and 3.

Max Number of Retransmits   The configured value of the maximum number of times a request packet is 

retransmitted.

The configured timeout value, in seconds, for request retransmissions.

The configured value for RADIUS accounting mode indicating if accounting is 
currently enabled.

This command displays the configured RADIUS servers.