Netgear gsm7312 Manuale Utente

11-2

FSM7326P Power Over Ethernet Commands

Attached to the PSE is the UPS. A UPS is connected to each device that requires alternative power. 
With Power over Ethernet, this function is centralized in a UPS connected to the PSE. Note that 
this may require further changes in the environmental conditions of the room needing to support 
this UPS with all of its electrical and cooling requirements. 

The current delivered to each node is limited to 350 milliamps. The total amount of continuous 
power that can be delivered to each node, taking into account some power loss over the cable run, 
is 12.95 watts. IP phones and wireless LAN access points typically consume 3.5 to 10 watts. 
Power is carried on two wire pairs, to comply with safety standards and existing cable limitations.

Management may also be added to monitor and control the PSE. This management function may 
be integrated into a standard network management platform using the simple network management 
protocol (SNMP) or through a custom platform. Beyond the basic control of the PSE, the 
management stations provides additional power management functions, like power quality of 
service (QoS) where key users are given higher priority to power in the event of a outage. 

Voice-over IP (VoIP), is the transmission of telephone calls over a data network like one of the 
many networks that make up the Internet.

Other NETGEAR products that work with 7000 Series L3 Switch:

•

WG302

•

WG602

•

WAG302

This section shows the additional CLI commands required to provide the management interface to 
the Power-over-Ethernet (PoE) function. The commands only applies to FSM7326P model.

For the FSM7326P, only ports 0.1-0.24 are eligible to participate in the PoE function.

This command enables or disables the Power over Ethernet function on the specified port(s).

enable