Netgear gsm7312 Manuale Utente

Switching Commands

7-15

enable

config network webmode <enable|disable>

 

This command specifies whether or not the switch should allow access to the Java applet in the 
header frame of the Web interface. When access is enabled, the Java applet can be viewed from the 
Web interface. When access is disabled, the user cannot view the Java applet. 

enable

config network javamode <enable|disable>

 

This command changes the name of the prompt. The length of name may be up to 64 alphanumeric 
characters.

config prompt <system prompt>

This command displays serial communication settings for the switch.

 

Specifies the time, in minutes, of inactivity on a Serial port connection, after 
which the Switch will close the connection. Any numeric value between 0 and 
160 is allowed, the factory default is 5. A value of 0 disables the timeout. 

The default baud rate at which the serial port will try to connect. This is selected 
from a pull-down menu. The available values are 1200, 2400, 4800, 9600, 
19200, 38400,57600, and 115200 baud. The factory Default is 9600 baud. 

The number of bits in a character. The number of bits is always 8. 

Whether Hardware Flow-Control is enabled or disabled. Hardware Flow 
Control is always disabled.

The number of Stop bits per character. The number of Stop bits is always 1.

The Parity Method used on the Serial Port. The Parity Method is always None.