Quantum DLT-V4 Guida Utente
Chapter 2 Installing the Internal SCSI Tape Drive
Installation Steps
DLT-V4 Product Manual
5
If you attach the tape drive to a narrow (50-pin) SCSI bus, you must use a
customer-supplied 68-pin to 50-pin adapter that terminates the unused 18
pins. These adapters are sometimes labeled
high-byte termination
.
Make sure the total length of the SCSI bus does not exceed the ANSI SCSI
standard of 19 feet (6 meters) for an SE SCSI bus, 40 feet (12 meters) for an
LVD SCSI bus with multiple devices, or 82 feet (25 meters) for an LVD
SCSI bus with a single device.
Installation Steps
2
To install the tape drive, perform the following tasks in this order. Follow
the detailed instructions on the pages listed below.
Table 1 Installing the DLT-V4
Internal SCSI Tape Drive —
Overview
Internal SCSI Tape Drive —
Overview
Step
Instruction
Page
1
Unpack and check the tape drive for shipping
damage.
2
Select a server or workstation to host the tape
drive.
3
Download and install the current device
driver (if required) (see
4
Set the SCSI ID.
5
Terminate the tape drive.
6
Install the tape drive in the server or
workstation. Connect all the cables and secure
the tape drive in the system.
7
Confirm the installation.