Quantum DLT-V4 Guida Utente
Chapter 4 Installing the Internal SATA-to-USB Tape Drive
USB Requirements
DLT-V4 Product Manual
24
USB Requirements
4
The tape drive must be connected to a USB 2.0 port.
Installation Steps
4
To install the tape drive, perform the following tasks in this order. Follow
the detailed instructions on the pages listed below.
Table 4 Installing the DLT-V4
Internal SATA-to-USB Tape
Drive
Internal SATA-to-USB Tape
Drive
Step
Instruction
Page
1
Unpack and check the tape drive for shipping
damage.
2
Select a server or workstation that is to host
the tape drive.
3
Download and install the current device
driver (if required) (see
4
Install the tape drive in the server or
workstation. Connect the power and data
cables to the tape drive.
5
Connect the SATA data cable to the SATA-to-
USB adapter. Connect the SATA-to-USB
adapter to the host PC motherboard or USB
HBA.
6
Complete the installation by securing the tape
drive in the host server or workstation and
turning on power.
7
Confirm the installation.