Quantum DLT-V4 Guida Utente
DLT-V4 Product Manual
33
Chapter 5
5
Installing the Tabletop
SCSI Tape Drive
This section contains step-by-step instructions for installing the tabletop
SCSI tape drive.
Equipment Required
5
You need no special tools to install the DLT-V4 SCSI tabletop tape. You
will need a ballpoint pen to change the SCSI ID switch on the rear panel
of the tape drive.
SCSI Bus and Cable Requirements
5
The DLT-V4 SCSI interface tape drive incorporates a wide Ultra160 low-
voltage differential (LVD) small computer system interface (SCSI) bus,
but you can also attach it to a single-ended (SE) SCSI bus.
Make sure the SCSI host adapter or controller supports these
Make sure the SCSI host adapter or controller supports these
configurations. If you connect the tape drive to an SE bus, or if there are
SE devices attached to the same SCSI bus, the tape drive’s performance is
limited to the maximum data transfer speed and maximum cable lengths