Champion dh-1000 Istruzione Sull'Installazione
29
1. Locate the control cabinet keys on the rear of the control cabinet.
2. Remove 1 key to unlock the cabinet; do not remove the other key.
3. Unlock the control cabinet and remove the cover.
4. Locate the power cord on the left rear side of the control cabinet.
5. Locate the Machine Electrical Connection Data Plate mounted near the terminal block.
2. Remove 1 key to unlock the cabinet; do not remove the other key.
3. Unlock the control cabinet and remove the cover.
4. Locate the power cord on the left rear side of the control cabinet.
5. Locate the Machine Electrical Connection Data Plate mounted near the terminal block.
6. Check the power cord terminal connections at the main terminal board.
Warning:
Disconnect the main electric supply and place a tag at the fuse or disconnect switch
indicating that work is being performed on that circuit.
Warning:
The dishwasher must be electrically grounded according to all local codes and regulations
governing the installation of electrical service.
The
MACHINE ELECTRICAL CONNECTION DATA PLATE
is the certified authority for the
dishwasher power requirements.
DO NOT
use electrical data from any other source
unless an authorized factory representative instructs you to use other data.
Machine Electrical
Connection Data Plate
Main terminal block
Installation Guide
Electrical Connections (1000 Series LT)
1000 Series LT - Installation Guide
Utility Connections - 1000 Series LT
Power:
115VAC 15Amp circuit
Water supply:
3/4" NPT hot water supply (140°F/60°C minimum)
20 ± 5 psi/138 ± 35kPa flow pressure. Installation of 0-60 psi/0-414 kPa
pressure gauge is recommended.
Drain:
1-7/8" stainless steel, slip-fit hose connection
Max flow: 15 Us gal/min. (13.5 Imperial gal/min) 57liters/min.
Chemicals:
Detergent, rinse-aid, and sanitzer pumps are standard equipment.
Chemicals supplied by a chemical supplier
Chemical Dispensing Pumps - Factory Installed -1000 Series LT
•
All pumps use liquid chemicals
•
Detergent pump capacity =
165ml / min @ 108 RPM
Factory setting for detergent =
10 sec. / 28ml
•
Sanitizer pump capacity =
35cc/min @ 14RPM
Factory setting for Sanitizer=
14cc in 23 sec.
maintains 50PPM concentration of
5.25% sodium hypochlorite during
the final rinse cycle.
•
Rinse-aid pump capacity =
21 ml / min @ 14RPM
Factory setting for rinse-aid
10 sec. / 3.5 ml