Sony STR-DG910 Guida Utente

US

D:\CANNES\SONY_HA\JOB 2007\STR-DG910\IM_910_US\STR-DG910_data\GB03CON_STR-
DG910-UC.fm

STR-DG910

3-094-430-11 (1)

Measurement starts in 5 seconds and the 
display changes as follows:
A. CAL [5] t A. CAL [4] t A. CAL [3] t 

A. CAL [2] t A. CAL [1]

The measurement process will take 
approximately 30 seconds to complete.
The table below shows the display when 
measurement starts.

You cannot measure the speaker height of the 
surround speakers and the surround back speakers. 
Set this value using the “SUR POS.” parameter in 
the SYSTEM menu (page 59).

The measurements may not be performed correctly 
or Auto Calibration cannot be performed when 
special speakers, such as dipole speakers are used.

The Auto Calibration function will be 
canceled when you do the following during the 
measurement process:
– Press ?/1, input buttons or MUTING.
– Press SPEAKERS (OFF/A/B/A+B) on the 

receiver.

– Change the volume level.
– Press AUTO CAL again.
– Connect the headphones.

When the measurement ends, a beep 
sounds and the measurement result 
appears on the display.

V/v repeatedly to select 

Speaker existance

TONE

Speaker gain, distance, frequency 

response

T.S.P.

Sub woofer gain and distance

WOOFER

When the 

measurement 

process 

completes 

properly

SAVE

Proceed to step 

2.

When the 

measurement 

process fails

ERROR 

XXXX

See “When 

RETRY

Performs the Auto 

Calibration again.

SAVE

Saves the measurement 

results and exits the setting 

process.

WARN CHK

Displays warning 

concerning the 

measurement results. See 

PHASE

Displays the phase of each 

speaker (in phase/out of 

phase). See “When you 

DISTANCE

Displays the measurement 

result for speaker distance.

LEVEL

Displays the measurement 

result for speaker level.

EXIT

Exits the setting process 

without saving the 

measurement results.