Sony DCR-TRV30 Manuale

Adding an audio sound on a recorded tape

Choose a connection mentioned before, and connect audio equipment or microphone to
your camcorder. Then follow the procedure below.

(1) Insert the recorded tape into your camcorder.
(2) Set the POWER switch to VCR on your camcorder.
(3) Locate the recording start point by pressing N on the Remote Commander.

Then press X at the point where you want to start recording to set your
camcorder to the playback pause mode.

(4) Press AUDIO DUB on the Remote Commander. The green 

X

 indicator

appears on the screen.

(5) Press X on the camcorder or on the Remote Commander and start playing

back the audio you want to record at the same time.
The new sound is recorded in stereo 2 (ST2) during playback. During
recording new sound, the red 

 appears on the screen.

(6) Press x on the Remote Commander or on your camcorder at the point where

you want to stop recording.

Monitoring the new recorded sound

To play back the sound

Adjust the balance between the original sound (ST1) and the new sound (ST2) by
selecting AUDIO MIX in 

 in the menu settings (p. 100).

Five minutes after when you disconnect the power source or remove the battery pack,
the setting of AUDIO MIX returns to the original sound (ST1) only. The default setting
is original sound only.

Audio dubbing

ST1

ST2

V C R S E T

R E T U R N

H i F i

S OU N D

A U D I O M I X
A / V

c

D V OU T

[ ME NU ]  :  E ND