Roland fp-4 Guida Utente
15
Before You Play
1.
Make sure that the [Power] switch located at
the rear of the keyboard is off (in the upper
position).
the rear of the keyboard is off (in the upper
position).
fig.PowerOn.eps
2.
Turn the [Volume] knob all the way toward the
left to minimize the volume.
left to minimize the volume.
3.
Connect the supplied Power Cord to the
supplied AC adaptor.
supplied AC adaptor.
4.
Connect the AC adaptor to the FP-4’s DC In
jack, and plug the power cord into an
electrical outlet.
jack, and plug the power cord into an
electrical outlet.
5.
Loop the AC adaptor cord around the cord
hook to fasten it in place.
hook to fasten it in place.
To prevent the inadvertent disruption of power to your
unit (should the plug be pulled out accidentally), and to
avoid applying undue stress to the AC adaptor jack,
anchor the power cord using the cord hook, as shown in
the illustration.
Even if the cord is fastened, strong tension applied to the
cord may cause it to be damaged or broken. Be careful
not to pull the cord accidentally, or to apply strong
pressure to it.
unit (should the plug be pulled out accidentally), and to
avoid applying undue stress to the AC adaptor jack,
anchor the power cord using the cord hook, as shown in
the illustration.
Even if the cord is fastened, strong tension applied to the
cord may cause it to be damaged or broken. Be careful
not to pull the cord accidentally, or to apply strong
pressure to it.
Depending on the circumstances of a particular setup,
you may experience a discomforting sensation, or
perceive that the surface feels gritty to the touch when
you touch this device. This is due to an infinitesimal
electrical charge, which is absolutely harmless.
However, if you are concerned about this, connect the
ground terminal (see figure) with an external ground.
When the unit is grounded, a slight hum may occur,
depending on the particulars of your installation. If you
are unsure of the connection method, contact the nearest
Roland Service Center, or an authorized Roland
distributor, as listed on the “Information” page.
you may experience a discomforting sensation, or
perceive that the surface feels gritty to the touch when
you touch this device. This is due to an infinitesimal
electrical charge, which is absolutely harmless.
However, if you are concerned about this, connect the
ground terminal (see figure) with an external ground.
When the unit is grounded, a slight hum may occur,
depending on the particulars of your installation. If you
are unsure of the connection method, contact the nearest
Roland Service Center, or an authorized Roland
distributor, as listed on the “Information” page.
Unsuitable places for connection
• Water pipes (may result in shock or electrocution)
• Gas pipes (may result in fire or explosion)
• Telephone-line ground or lightning rod (may be
dangerous in the event of lightning)
Getting Ready to Play
Connecting the AC Adaptor
Off
Upper
Position
AC Outlet
AC Adaptor
Power Cord
(AC Adaptor)
Power Cord
Ground Terminal
Cord Hook
FP-4-e.book 15 ページ ２００７年５月２４日 木曜日 午後７時１０分