Kreg dk1100tp pneumatic hole machine Guida Utente

R

DK1100 TP/FP

17

B) Adjusting the Drill Bit Depth Stop

A Drill Bit Depth Stop is provided to stop the Drill Bit forward 
motion and control the Drill Feed Cylinder cycle. When the 
head of the Drill Bit Depth Stop fully engages the Depth 
Control Switch the forward motion of the Drill Bit is stopped 
and reversed to complete the drilling cycle. Before adjusting 
the Drill Bit Depth Stop make certain your machine is 
DISCONNECTED from the AIR SUPPLY and/or ELECTRICAL 
SUPPLY. Cycle the machine via the foot switch several 
times to remove air from the system. Without an air supply 
or electrical supply you can be certain the machine will not 
accidentally engage while you are performing maintenance.

Step 1:  Loosen the Lock Nut on the Depth Control Adjuster. 
 

Adjust the Depth Control Adjuster the approximate  

 position.
Step 2:  Push the Drill Bit Drive Assembly forward until the
 

Drill Bit pilot point is slightly away from the Fence. 

For 
 

1/2” and 3/4” material, push your drill bit up to be 

 

approximately 1/8” from the tip to the edge of the 

fence. 
 

For 1-1/2” material, push your drill bit up to be 

 

approximately 1” from the tip to the edge of the fence.

Step 3:  Adjust the Drill Depth Control Adjuster until the Head  
 

fully depresses the plunger on the Depth Control 

Switch.
Step 4:  Tighten the Lock Nut to lock the Depth Control 
 

Adjuster in position.

Step 5:  Pull the Drill Bit Drive Assembly back into the 
 resting 

position.

Lock Nut

Depth Control 
Switch

Head

Depth Control Adjuster

The Fence can be adjusted to align the pocket hole to the 
center of material of different thicknesses. When adjusting the 
Fence make sure that the Fence remains perpendicular to the 
Guide Plate. A Reference Scale has been provided to approxi-
mate the fence setting for 1/2”, 3/4”, and 1-1/2” thick material. 
These correspond to the “A”, “B”, and “C” lines on the Refer-
ence Scale.

Step 1: Loosen the (4) Socket-head Cap Screws contained  
 

  below the surface of the Fence.

Step 2: Align the Fence perpendicular to the Guide Plate for
 

the setting that corresponds to the material thickness.

Step 3: Tighten the (4) Socket-head Cap Screws to lock the  
 

Fence into position.

Setting “C” = 1-1/2” Material

*

*Approximate fence setting.

Shown for use with 1/2 & 3/4” Settings.

Shown for use with 1-1/2” Setting.

Reference Scale

Access to Socket-

Head Cap Screws

Adjusting the Machine For Stock Thickness