Rollei Dk4010 Guida Utente

Inserting the Batteries | Inserting the Memory Card | 

 | Setting the Date and Time | Using the 

Contents (Top page) Detailed Contents

Turning the Camera On

1

Press the POWER button H.

The startup screen is displayed for a few seconds and then the normal 
screen for the selected camera mode appears.

A

Important

• Check that a memory card is inserted in the camera before turning the camera on.
• Remove the lens cap before turning the camera on.

B

Note

• In modes other than "

G" mode, you can 

choose whether the camera starts up with the 
LCD panel used as an EVF (electronic 
viewfinder) or as an LCD monitor. (Æ p.159)

• Press the POWER button 

H again to turn 

the camera off.

„

Guide to viewing the low battery warnings and replacing

 the batteries

When the low battery warning shown below appears on the screen, immediately load new or fully charged 
batteries.

When the battery charge is completely depleted, the "LOW BATTERY" 
message appears on the LCD monitor.
The amount of power consumed by a digital camera varies considerably 
depending on the environment in which it is being used.
Even if the battery level icon indicates that there is still charge in the 
batteries, the camera may turn itself off in some camera operating 
conditions. When this occurs, load new or fully charged replacement 
batteries.

Charge very low.

Camera will not operate. 
Insert new batteries.

LOW BATTERY