Enterasys csx200 Manuale Utente

Chapter 2: About the CSX200

2-4

CSX200 Installation Guide

The CSX200 firmware supports IEEE 802.1d bridging, and IP and IPX routing,. Wide Area 
Networking includes 

and

. Remote access is via Full 

or Fractional T1, E1, Synchronous, Digital Data Service, ISDN, or HDSL connections.

This device supports industry-standard protocols, security features, compression algorithms and 
network management tools to ensure interoperability with equipment from other vendors.

The CSX200 provides a standard 802.3 Media Access Control (MAC) layer for Ethernet 
communications. All bridging and routing protocols are supported across the Ethernet link.

This device supports the following WAN protocols over the WAN port:

Point-to-Point Compression Control Protocol (CCP) as defined by RFC 1962

Dynamic Host Configuration Protocol (DHCP) as defined by RFC 1541

Network Address Translation (NAT) routing as defined by RFC 1631

Point-to-Point Protocol (LCP) as defined by RFC 1661

Point-to-Point Protocol (BNCP) as defined by RFC 1638

Point-to-Point Protocol (IPCP) as defined by RFC 1332

Point-to-Point Protocol (IPXCP) as defined by RFC 1552

Password Authentication Protocol (PAP) and Challenge Handshake Authentication Protocol 
(CHAP) under PPP as defined by RFC 1994

Point-to-Point Protocol Link Quality Monitoring (LQM) as defined by RFC 1333

Point-to-Point Protocol Multilink Protocol (MP) as defined by RFC 1717

Frame Relay Link Management Interface (LMI) as defined by ANSI T1.617 Annex D and ITU 
Q.933 Annex A

Frame Relay Data Encapsulation as defined by RFC 1490

Frame Relay Data Compression Protocol (DCP) as defined by FRF.9