Enterasys csx150 Guida Utente
Small Office Remote Access Switch 535
S
YSTEM
C
OMMANDS
WAN Commands
sentry ace
Attempts an authentication session using ACE. The system will report whether the
authentication attempted was successful or rejected.
authentication attempted was successful or rejected.
WAN C
OMMANDS
The following commands are used to display current system WAN diagnostic information:
wan fr-ietf stats [device/fr_accessname_dlci] [prot]
Displays the current frame relay IETF related statistics. Refer to
, for a
list of available statistics and their definitions.
wan stats
Displays the current WAN statistics. Refer to
for a list of available statistics and
their definitions.
X.25 C
OMMANDS
The following commands are used to display information concerning both the status and traffic
statistics of a particular X.25 connection. A command is also available to allow the X.25 and LAPB
packet tracing options to be enabled or disabled.
statistics of a particular X.25 connection. A command is also available to allow the X.25 and LAPB
packet tracing options to be enabled or disabled.
trace lapb [on/off]
Enables or disables the LAPB data link information packet tracing option. This feature displays
up to 15 octets of the packet. To display the log file, issue the
up to 15 octets of the packet. To display the log file, issue the
dr
console command. This option
is initially disabled.
trace x25 [on/off]
Enables or disables the X.25 packet tracing option. This feature displays up to 15 octets of the
packet. To display the log file, issue the
packet. To display the log file, issue the
dr
console command. This option is initially disabled.
x25 clear
Clears the statistics counters associated with the
x25 stat
command for the currently
selected access and LCN.
x25 clearall
Clears all statistics associated with the
x25 stat
command for the currently selected access
and LCN.
x25 display [access name]
Displays the configuration for the default X.25 access if no access name is specified. If an access
name is specified, the configuration for that access is displayed. Note that this also includes any
configuration information of any PVCs associated with this access.
name is specified, the configuration for that access is displayed. Note that this also includes any
configuration information of any PVCs associated with this access.
x25 l <LCN “m”>
The “l” option will set the Logical Channel Number (LCN) index specified by “m” as the
default LCN for subsequent commands entered without an explicit LCN specifier. LCN “m”
will remain the default LCN until the default is changed through reissuing the
default LCN for subsequent commands entered without an explicit LCN specifier. LCN “m”
will remain the default LCN until the default is changed through reissuing the
x25 l <lcn
“m”>
command.