Enterasys micrommac 22es Istruzione Sull'Installazione

The boot –l command downloads and saves the operational image to 
non-volatile memory, erases the existing Flash memory, copies the new 
image from non-volatile memory to Flash memory, and then executes the 
image. 

The boot –l command display looks like this:

The boot –l command is supported only if the self-boot option 
is installed.

After executing a boot –l, the ls command may not show the 
newly-loaded image.

monitor:: boot –l
Enter boot file name [(ip) “oper.56.enet”, \

   (mop) “OPER_56_ENET.SYS”]::

Requesting default boot file “OPER_56_ENET.SYS” for \
MOP/VMS loads and “oper.56.enet” for all other protocols.\
Unanswered requests shown as ‘?’, transmission errors as\ ‘*’.

Requesting boot from 192.9.200.88 via Ethernet...
  Booting BFS file using open delay of 8

Booting from 192.9.200.88

Header received OK.  Received data blocks shown as ‘.’.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. 
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. 
. . . . . . . . . . . . . . . . . . . .EOF 

           Saving image into storage device ... 

Erasing device
|----------------------------|
..............................
Erase completed
   Storing image .............
   Storage completed

Beginning execution of image...
Annex Command Line Interpreter * Copyright 1993, 1995\ Xylogics, 
Inc.
annex: