Enterasys micrommac 22es Istruzione Sull'Installazione

Chapter 3: ROM Monitor Commands

The command display looks like this:

To provide remote access to the Micro-CS ROMs:

From a site local to the Micro-CS:

Set the Micro-CS into test mode so the monitor prompt appears on 
the console.

Set the modem into auto-answer mode.

From the Micro-CS console port:

At the monitor prompt, enter console-baud.

At the Select baud rate prompt, enter the appropriate baud rate or 
auto.

Connect the modem to the Micro-CS’s console port.

This command has no effect on the port’s baud rate after the 
Micro-CS

 is booted

monitor::

 

Remote Diagnostic Test Mode

In order to use the remote diagnostic functionality, you
must first connect a modem to the console port of the
Annex. The modem should be configured such that DTR is
forced on, carrier detect and DSR are set normal, and
auto-answer is enabled. Once this is done, contact your
service representative for remote diagnostic maintenance.

To enter “Autobaud Mode”, please type “Auto”. To
“manually” configure the Annex console port, please type
in the desired baud rate. To return to the “monitor::”
prompt strike the “carriage return <CR>” key.

[Baudrate Range: 50-9600 BAUD]

Select Baudrate []::