Pantech Matrix Pro Guida Utente

Pagina di 258
245
Chapter 16. Safety and warranty
FCC & Industry Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject 
to the following two conditions: (1) this device may not cause harmful 
interference, and (2) this device must accept any interference received, 
including interference that may cause undesired operation.
Your mobile device is a low power radio transmitter and receiver. When 
it is ON, it receives and also sends out radio frequency (RF) signals. 
In August 1996, the Federal Communications Commission (FCC) 
adopted RF exposure guidelines with safety levels for mobile devices. 
Those guidelines are consistent with safety standards previously set 
by both U.S. and international standards bodies: American National 
Standard Institute (ANSI), National Council of Radiation Protection 
and Measurements (NCRP), and International Commission on Non-
Ionizing Radiation Protection (ICNRP). Those standards were based 
on comprehensive and periodic evaluations of the relevant scientific
literature. The design of your phone complies with the FCC guidelines 
and applicable.
Statement according to FCC part 15.105
NOTE: This equipment has been tested and found to comply with 
the limits for a Class B digital device, pursuant to Part 15 of the FCC 
Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This equipment 
generates, uses and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause 
harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation. If 
this equipment does cause harmful interference to radio or television 
reception, which can be determined by turning the equipment off and on, 
the user is encouraged to try to correct the interference by one or more 
of the following measures:
  Reorient or relocate the receiving antenna.
  Increase the separation between the equipment and receiver.
  Connect the equipment into an outlet on a circuit different from that 
to which the receiver is connected.
  Consult the dealer or an experienced radio/TV technician for help.
Statement according to FCC part 15.19: 
This device complies with Part 15 of the FCC Rules. Operation is subject 
to the following two conditions: (1) this device may not cause harmful 
FCC & INDUSTRY COMPLIANCE