Pantech pursuit ii Guida Utente

FCC Regulatory Compliance

This device complies with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1)

this device may not cause harmful interference, and

(2) this device must accept any interference received,

including interference that may cause undesired

operation.
Your mobile device is a low power radio transmitter

and receiver. When it is ON, it receives and also sends

out radio frequency (RF) signals. In August 1996, the

Federal Communications Commission (FCC) adopted

RF exposure guidelines with safety levels for mobile

devices. Those guidelines are consistent with safety

standards previously set by both U.S. and international

standards bodies: American National Standard Institute

(ANSI), National Council of Radiation Protection and

Measurements (NCRP), and International Commission

on Non-Ionizing Radiation Protection (ICNRP). Those

standards were based on comprehensive and periodic

evaluations of the relevant scientific literature. The

design of your phone complies with the FCC guidelines

and applicable.

Statement according to FCC part 15.105

note: This equipment has been tested and found

to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against

harmful interference in a residential installation. This

equipment generates uses and can radiate radio

frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications. However, there

is no guarantee that interference will not occur in a

particular installation. If this equipment does cause

harmful interference to radio or television reception,

which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and

receiver.

•

Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV

technician for help.