NEC FP1375X Manuale Utente

SpectraView either could not find the monitor ID in the registry of device names
or the monitor did not respond to the test digital command sent to it.

a. Check the connection at the monitor.  For Mitsubishi DP2060U monitors, the

Digital Cable should be connected to Signal B, not Signal A.  Signal A does not
provide DC communication lines, or;

b. You have connected the Digital Cable in reverse; the VGA connector at the USB

end should always connect to the graphics card and never to the monitor, or;

c. Since three microprocessors are involved in the SpectraView configuration

(DDC controller in the monitor, microprocessor in the Digital Cable, and the
host CPU), it is not unusual for these devices to get “out of sync” on power-
down/power-up sequences.  To resync the microprocessors, unplug the USB
cable from the Digital Cable and restart the computer.  Replug the digital
Cable USB connector and relaunch SpectraView.

If the DeltaE Tracking graph shows a bad calibration (DeltaE value of four or
greater any place in the graph), it is probably from a bad dark current calibration.
Repeat calibration with the sensor in the darkest possible location (covered with
an opaque cloth or material, if possible) during the Measure Dark Current step.