NEC 4205W Manuale Utente

9

Connecting your PC or Macintosh computer to your
PlasmaSync 4205W will enable you to display your
computer's screen image for an impressive presentation. The
PlasmaSync 4205W supports the signals described on page
44.

To connect to a PC, Macintosh or compatible graphics
adapter, simply:

1. Turn off the power to your PlasmaSync 4205W and

computer.

2. If your PC does not support XGA/SVGA/VGA you will

need to install an XGA/SVGA/VGA graphics board. Con-
sult your computer's owner's manual for your SXGA/XGA/
SVGA/VGA configuration. If you need to install a new
board, see the manual that comes with your new graphics
board for installation instructions.

3. The PlasmaSync 4205W provides signal compatibility with

VESA 1280

21024@60MHz (SXGA). However, it is not

recommended to use this resolution due to image readabil-
ity on the monitors 853

2480 native pixel resolution panel.

4. Use the signal cable that's supplied to connect your PC or

Macintosh computer to the PlasmaSync 4205W. For
Macintosh, use the supplied monitor adapter to connect
to your computer's video port.

5. Turn on the PlasmaSync 4205W and the computer.

6. If the PlasmaSync 4205W goes blank after a period of

inactivity, it may be caused by a  screen saver installed on
the computer you've connected to the PlasmaSync
4205W.

When using a Macintosh with the PlasmaSync 4205W, the
following three display standards are supported using the
included Macintosh adapter :

13" fixed mode

16" fixed mode

19" fixed mode

The 13" fixed mode is recommended for the PlasmaSync
4205W.

You can connect your PlasmaSync 4205W to a document
camera. To do so, simply:
1. Turn off the power to your PlasmaSync 4205W and

document camera.

2. Use a standard video cable to connect your document

camera to the Video input on your PlasmaSync 4205W.

3. Turn on the PlasmaSync 4205W and the document cam-

era.

Note: Refer to your document camera's owner's
manual for more information about your camera's video
output requirements.

Use common RCA cables (not provided) to connect your
VCR or laser disc player to your PlasmaSync 4205W. To
make these connections, simply:

1. Turn off the power to your PlasmaSync 4205W and

VCR or laser disc player.

2. Connect one end of your RCA cable to the video out-

put connector on the back of your VCR or laser disc
player, connect the other end to the Video input on your
PlasmaSync 4205W. Use standard RCA audio patch
cords to connect the audio from your VCR or laser disc
player to your PlasmaSync 4205W (if your VCR or
laser disc player has this capability). Be careful to keep
your right and left channel connections correct for stereo
sound.

3. Turn on the PlasmaSync 4205W and the VCR or laser

disc player.

Note: Refer to your VCR or laser disc player owner's
manual for more information about your equipment's
video output requirements.

You can connect your PlasmaSync 4205W to a DVD player.
To do so, simply:

1. Turn off the power to your PlasmaSync 4205W and

DVD player.

2. Use a standard video cable to connect your DVD player

to the Y, Cb, and Cr inputs on your PlasmaSync 4205W.
Or use the DVD-player's S-Video output. Use a stand-
ard S-Video cable to connect to the S-Video input on
the PlasmaSync 4205W.

3. Turn on the PlasmaSync 4205W and the DVD player.