NEC e242 Guida Utente
2
.
,
If the SIM card is not fully inserted when the battery is replaced, damage to the SIM card can occur.
/
If the SIM card is already fitted, see “Start-up” on page 4.
Removing a SIM card
☛
With the battery removed, push the short and straight end of the SIM card with your thumb to slide it gently in the direction of arrow
➆
➔
Lift the
SIM card after it is completely removed from the holder.
,
Be careful not to damage electric parts of the SIM holder when removing a SIM card.
Charging the battery
Before trying to use your phone, insert the phone’s battery, connect the NEC battery charger (AC adapter) supplied with your phone to a suitable mains
power socket.
☛
Pull open the charger connector cover gently.
,
Be careful when handling the charger connector cover. Do not pull strongly.
☛
Connect the charger plug (AC adapter) into the charger connector at the bottom of the phone..
2
If your phone is turned on and charging starts, the battery charging icon will be displayed. LED
will turn on in red while charging. When charging is complete, the LED will turn off.
2
You are recommended to switch off the phone while charging. If you need to receive calls, your
phone can be switched on and left in standby while being charged, although the total time
taken to charge is then increased.
☛
Disconnect the charger plug (AC adapter) gently and vertically from the charger connector in
the opposite direction of arrow.
2
Make sure to disconnect the charger plug, holding the arrow mark on the plug, not the
cable. Otherwise damage to the charger connector can occur.
The colour on the display shows the charging status of battery.
Battery
Finger tab
Holder
SIM card
Notches
Tabs
About 3 mm
Check that there is no gap
between the rear cover
and the phone body.
between the rear cover
and the phone body.
Rear cover
About 3 mm
Charger connector
Charger plug
Charger connector
cover
cover