U-Line 1115R Istruzione Sull'Installazione
www.U-LineService.com
2
04/2006
Custom 1/4'' Thick Door Panel Insert
Door Panel Preparation
A custom door panel can be inserted into the doorframe.
Custom door panels can be flat or raised, as long as the
maximum panel thickness where inserted into the door
reveal (channel) is 1/4"-thick. For raised panels, the depth
of the reveal is 1/4" on all four sides.
Custom door panels can be flat or raised, as long as the
maximum panel thickness where inserted into the door
reveal (channel) is 1/4"-thick. For raised panels, the depth
of the reveal is 1/4" on all four sides.
IMPORTANT
Raised panels will reduce the door’s 90° swing/zero
clearance if the unit is installed next to a wall or similar
type of structure.
clearance if the unit is installed next to a wall or similar
type of structure.
Cut the panel insert to the following dimensions.
Custom 1/4" Dimensions for 1175 Black & White units:
Width:
22-15/16"
Height:
26-15/16"
Custom 1/4" Dimensions for 1115 Black units:
Width:
13-15/16"
Height:
26-15/16"
The door panel must not weigh more than 20 lbs.
Door Panel Installation
Install the insert as follows:
CAUTION
Use care when handling the insert. Insert edges may be
sharp.
sharp.
1. Remove top hinge screw pin with Phillips head
screwdriver. Remove door by tilting forward and lifting
off bottom hinge pin.
off bottom hinge pin.
2. Pull door gasket out of
groove (top edge of door
only). Start in the middle
and pull outward, moving
toward the edge (see
Figure 2). This may take
some force.
only). Start in the middle
and pull outward, moving
toward the edge (see
Figure 2). This may take
some force.
3. Remove two outside
screws holding door
handle. Slightly separate
door handle from door
(see Figure 3).
handle. Slightly separate
door handle from door
(see Figure 3).
4. Pull handle up and off.
IMPORTANT
Use care not to damage magnet , located on door bottom
when installing door insert. Do not set door on bottom
edge when pushing insert into place.
when installing door insert. Do not set door on bottom
edge when pushing insert into place.
5. Slide custom door panel insert into 1/4-inch channel in
door front.
6. Holding door gasket out of the way, replace handle on
door, making sure it is seated properly on insert and
that screw holes line up.
that screw holes line up.
7. Install two small screws removed in Step 3.
8. Starting at the corners and working inward, push door
gasket into place on door.
9. Place door on bottom hinge pin and install upper hinge
screw.
Figure 1
Figure 2
Figure 3