U-Line ada24rglb13 Manuale Utente

To check the actual product temperature in your unit, 
insert an accurate thermometer into a plastic (non-
breakable) bottle that is partially filled with water. 
Tighten the bottle cap securely (Figure 5).

Place the bottle in the desired area for 24 hours. Refrain 
from opening the unit during the testing period. After 24 
hours, check the temperature of the water. If required, 
adjust the temperature control in a small increment (See 
ADJUSTING TEMPERATURE). 

Factors which affect the internal temperatures of the 
cabinet include:

• Temperature setting.

• Ambient temperature where installed.

• The number of times and length of time a door is 

opened and closed.

• The amount of time the internal light is illuminated. 

(This affects primarily product on top rack or shelf.)

• Installation in direct sunlight or near a heat source.

To adjust the set point temperature:

1. Press and release either the WARMER (Figure 6, 4) or 

COOLER (Figure 6, 5) button to put the controller in 
the SET TEMPERATURE mode. The °F (or °C) symbol will 
begin to flash.

NOTE: If no further action is taken, this mode will self 
cancel in five seconds, and the original set-point 
temperature will be displayed.

2. Within five seconds (while the °F (or °C) symbol is 

flashing), press the WARMER or COOLER button as 
required to adjust the set point temperature.

3. The change will be set five seconds after adjusting the 

temperature, and the new set-point will be displayed 
(Figure 6, 3).

Many factors can affect the internal temperatures of the 
cabinet. They include:

• Temperature setting.

• Ambient temperature where installed.

• The number of times and length of time the door is 

opened and closed.

• The amount of time the internal light is illuminated. 

(This affects primarily product on top rack or shelf.)

• Installation in direct sunlight or near a heat source.

ULIN_0093_A

ULIN_0074_A