US Robotics usr8000a Guida All'Installazione

4

The following graphic is a representation of your system topology before the installation of the 

Broadband Router.

1

Turn off your PC and your Cable or DSL modem.

 If your Cable or DSL modem is connected to your PC 

using a USB cable, disconnect the USB cable from both 
your PC and from your Cable or DSL modem.

Locate the Ethernet cable from your Cable or DSL modem 
that is connected to your PC’s Ethernet adapter. Disconnect 
that Ethernet cable from your PC’s Ethernet adapter. 

Connect that Ethernet cable to the WAN port on the rear of 
the Broadband Router.

2

Connect one end of the supplied Ethernet cable to your 

PC's Ethernet adapter. Connect the other end to one of the 
LAN ports on the Broadband Router.

3

Turn on your Cable or DSL modem. Connect the included 
power cord to the power jack on the Broadband Router. Plug 

the power cord into a standard power outlet. The Broadband 
Router will automatically enter the self-test phase. After the 
self-test phase is complete, turn on your PC.

 When the Broadband Router is in the self-test phase, the 

Power LED may flash rapidly and all four LAN LEDs will light 

for approximately five seconds. Finally, the Power LED will 
continuously be lighted to indicate that the Broadband Router 
is operating normally and the self-test phase is complete.